![]() After all the data is played back, the chunklets return to the "normal" state. Any chunklets in the "logging" state enter "playback" state as their data is played back. Servicemag resume command causes playback of the log. log option, all chunklets on the disks in the drive magazine being serviced are marked as "normal,smag".Īny I/O on the chunklets marked "normal,smag" changes the states to "logging" and I/O is written to the logging logical disks. Servicemag command results in chunklet relocation that causes a dip in throughput. Servicemag command status for the given cage and magazine.Īccess to all domains is required to run this command. ![]() Summary status is given as default, and the -d option may be used to get detailed status. ![]() Permitted for Super, Service, Edit and Browse users. Servicemag command operations on a drive magazine are displayed. The 'unmark' option should not be used without consulting with HPE engineering. Servicemag start' operation reports a failure. Servicemag resume' to move the data back onto the drive(s) in this magazine once the Servicemag unmark' is issued during the relocation phase, the spin-down phase will indicate that the Relocation of chunklets is considered one step and can take from several minutes to several hours (depending on number of chunklets) to complete. Servicemag operation at the completion of the current step. Servicemag operation is a multi-step process, specifying unmark stops the Servicemag operation is stopped and its internal state is reset. Servicemag command informs the system manager that a drive magazine is replaced and that data services can be resumed. Servicemag command informs the system manager to log or relocate disks on a drive magazine so that the drive magazine can be removed for service. For a more accurate estimate, which will do runtime calculations based on the load on the system, please use ' servicemag status ' once ' servicemag start' or ' servicemag resume' has been initiated. Resume, the estimation will be based on empirical data with no I/O on the system. This option is used to estimate the length of time a d option is excluded, a summary of the status is displayed. Start subcommand, and cannot be used with the The disks specified in this option will be vacated out to be replaced and will not be logged. log option is also specified, logging will only apply to the remaining disks on the magazine and not the ones specified in this option. The PDs have to be in the same cage and magazine. Specifies one to four physical disks (by physical disk ID) that need to be serviced or replaced. Error messages are printed for those chunklets that could not be relocated. Specifies that as many chunklets as possible are relocated. Specifies that the serviced drive magazine's disk drives are valid and do not need to be replaced. Servicemag resume completes successfully. NOTE: This option can reduce the redundancy level of RAID sets until
0 Comments
Leave a Reply. |